Outboard Trim/Tilt Pin Wrench Tool MT0006-32mm x 4mm for Yamaha, Honda, Evinrude

Description

Application--
Fits for Trim Caps on ALL SHOWA manufactured Trim/Tilt Units,All Suzuki, Honda,Johnson, Evinrude,ALL Yamaha I4 2.8L (F175-F200),ALL Yamaha VMAX,Yamaha F115-F150,Yamaha 2-Strokes (115-225hp)
Function--
To rebuild a leaked device on outboard engine, hydraulic trim and tilt unit .Used to remove and install the Trim and Tilt Caps without damaging it and the steering cylinder
A Must Have--
Usually, you will put a little drift into one of those holes in the trim and tilt caps with a hammer. Than,you destroy these cap ,you will thrown them away,which cost a about hundred bucks. So, you really need the pin wrench to help you finish that case with ease
High Quality Material--
Made of high hardened 4140 impact grade steel,with silver oxide coating which is rust-resistance and durable to use.
Model: MT0006
Features
Same as Factory Tool: YB-06175-1A, YB-06548
1/2" Socket Drive. This is a precision made part for a tight fit.
180 ft-lb MIN Pin Strength
1 × Pin Wrench With 6 Replaceable Pins (3 x S-4mm pins, and 3 x S4.5mm pins)
Pin Wrench MT0006-32mm x 4mm
For all SHOWA manufactured Trim/Tilt Units for Yamaha, for Honda, for Evinrude. For more details, check the Pin Wrench Chart (4th image).
[ 180ft-lb MIN Pin Strength ] Equipped with 1/2" square drive for use with a torque wrench for proper installation.
3 pins to engage the caps and prevent damage.